Current state

 


At this point in time a newer faucet and base plate was installed to replace a leaky faucet. The previous faucet was not repairable.

The new water pump is up and running 24/7.

All siding is in place.

The solar pv station is working 24/7.

Interior and exterior painting remains to be done.


 UPDATE: I trimmed the length of the Wagner paint sprayer hose and was able to remove the clog. I have part of the hose that may be enough to use a paint bucket. I will need to drill holes in the bucket lid and attach to the bucket to prevent paint splashes.


Comments

Post a Comment

Popular posts from this blog

Siding for the rear side of the house

Image
 Yesterday, I began the process of adding siding to the long bare back wall of the house. Several years ago, I ordered some custom cut wood plank siding for the house. The style is 10" Dolly Varden and copies the original 1947 siding except for thickness. The original siding was cut from old growth wood while the newer sidin is cu from wood genetically engineered for fast growth and is weaker. I began by searching for transport sources. Two emerged: Home Depot 'Load n Go' trucks or U-Haul trucks. The Home Depot truck would not start because of battery issues, so I rented a 10' U-Haul truck. After bringing the scaffolding home, I headed back and lost the passenger side mirrors due to a utility pole placed too close to the roadside. Fortunately, the agent informed me that I had insurance and there would likely be only a deductable of around $150 or so. Confusion reigned at the rental store. Even after corrections, I drove away with more than I needed. The scaffold build ...
Read more

The rear gutter.

Image
I decided to make some improvements in the rear gutter downspout. The downspout attchment to the 2" pipe 'funnel' needs to be changed. A strong wind blew the downspout off the house. Reattchment was easy enough but a stronger more secure method is needed. A flexible pipe for the upper connection to the gutter is an improvement and will allow the gutter downspout to be attached to the house instead of floating in air. Some images of the back gutter downspout:  
Read more

Overflow pipe done, finally

  The pipe, as it turns out, was inclined just enough to prevent water flowing. Unfortunately a hard rain came and the tank overflowed into the basement's dirt floor. I had to lower the resting position of the pipe by carving out a bigger hole for the pipe through the block The material on the bottom had to be removed leaving only the mortor. For this I used a couple of legitimatte chisels and several impromptu chisels inluding a railrpoad spike. When done, the mortor was exposed from inside to outside and the water now flows freely. The gaping hole needs to be filled to prevent small critters and bees form entering and cold from freeing the water. I filled the hole with fiberglas insulation from both inside and outside.
Read more